Table of Contents
Advertisement
Quick Links
WLAN Access-Point flush-mounted
WLAN Access-Point flush-mounted
4582
WLAN Access-Point flush-mounted, PoE
4583
Operating and assembly instructions
Safety instructions
Electrical equipment may only be installed and assembled by a qualified electrician in
accordance with the relevant installation standards, guidelines, regulations, directives,
safety and accident prevention regulations of the country.
Hazard due to electric shock. Disconnect before working on the device. Take into
account all circuit breakers that supply dangerous voltages to the device.
Failure to comply with these instructions may result in damage to the device, fire, or oth-
er hazards.
These instructions are an integral component of the product and must be retained by the
end user.
Design and layout of the device
6LE001255A
(4)
(5)
(6)
(7)
Figure 1: Front view WLAN Access-Point
Page 1/7
(1)
(3)
(9)
(8)
03-2015
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Berker 4582
Summary of Contents for Berker 4582
- Page 1 WLAN Access-Point flush-mounted WLAN Access-Point flush-mounted 4582 WLAN Access-Point flush-mounted, PoE 4583 Operating and assembly instructions Safety instructions Electrical equipment may only be installed and assembled by a qualified electrician in accordance with the relevant installation standards, guidelines, regulations, directives, safety and accident prevention regulations of the country.
- Page 2 – Repeater for increasing the range in the WLAN network – Client for connecting to devices that do not have their own WLAN adapter. Detailed information on configuration and settings are available for downloading at www.berker.com. Correct use – only suitable for operation in indoor areas –...
- Page 3 The reed contact on the Access-Point is triggered. The orange LED (6) flashes The device restarts and loads the factory settings. If access to the Access-Point is no longer possible, please proceed according to the configu- ration instructions at www.berker.com. Information for electricians Installation and electrical connection DANGER! ç...
- Page 4 WLAN Access-Point flush-mounted WLAN Access-Point (order no. 4582) Connect device to power supply Figure 3: Connection supply voltage Live cables and network cables must always be laid separately from each other to the wall box. Run the mains cable into the wall box from below.
- Page 5 WLAN Access-Point flush-mounted Designation terminal Assignment Table 2: Assignment on the terminal block (1) of the WLAN Access-Point Figure 4 WLAN Access-Point, PoE (order no. 4583) Connect network cable Run the mains cable preferably into the wall box from below. „...
- Page 6 In the WLAN settings of the devices intended for the configuration, such as a tablet PC, „ select the the WLAN Access-Point. The Access-Point logs on in the network with the WLAN name (SSID) Berker. Log on at the Access-Point with the WLAN password wireless123. „...
- Page 7 Encryptions WEP, WPA, WPA2 Operating temperature -5 ... +45 °C Degree of protection accord. to DIN 60529 IP20 WLAN Access-Point flash-mounted, order no. 4582 Rated voltage 100 ... 240 V~ Mains frequency 50 ... 60 Hz Power consumption 1.8 W Conductor cross-section (mains cable) max.
Need help?
Do you have a question about the 4582 and is the answer not in the manual?
Questions and answers