Advertisement
replace
Healthy: 46%
charge 80%
internal R=88.1mΩ
rated:125A
rePlAce
the battery is near to, or has already reached the end of its useful life, replace battery.
bad cell, replace
Healthy:0%
charge:20%
internal r=100.2mΩ
rated:125A
BAd cell - rePlAce
Battery has interior damage, a bad cell or a short circuit, replace battery.
charge, retest
Healthy:39%
charge:20%
internal r=80.1mΩ
rated:125A
cHArGe - retest
unstable battery, recharge, retest. if the same test result appears after recharge and retest, the battery is damaged, replace battery.
Note: if a 'replace' result resulted from an 'in motorcycle mode', it may be that the motorcycle battery cable is not connected properly.
remove the battery cables and retest as out of motorcycle mode, before making a decision to replace the battery.
Note: After testing to exit, press the exit key to exit to the startup interface.
5.4.4.2.
battery out of motorcycle test
out-of motorcYcle means the battery connection to the motorcycle is removed.
choose the battery out of motor cycle test option from the main menu.
main menu
1. Quick test
2. Battery in motorcycle
3. out of motorcycle
4. review data
5. Print data
6. system setup
select battery type
After the battery charge status is selected, the tester will prompt to select the battery type, i.e. regular flooded, AGm flat Plate or
AGm spiral, Gel and efB battery.
Press up/down key to select battery type.
Press OK key to confirm .
Battery type
1. regular flooded.
2. AGm flat Plate.
3. AGm spiral.
4. Gel.
5. efB.
battery system and standard rating
the tester will test each battery according to the selected system and rating.
Use Up/Down key to select the actual standard and rating marked on the battery, see fig.2, following Battery Standard descriptions and
rating range chart.
select input
ccA
input correct test standard and rating, press enter, tester starts to test, 'testinG' is displayed, see below.
setting rate
500
ccA
it takes around 3 seconds to display the battery test result.
© Jack sealey limited
40ccA
9.68V
0ccA
10.64V
100ccA
12.08V
Original Language Version
mc105 | issue:1 23/11/16
Advertisement
