Advertisement
battery system standard and rating
the battery tester will test each battery according to the selected system and rating.
Use the Up/down key to select according to the actual system standard and rating marked on the battery. Refer to fig.2 below.
fig.2
cca: Cold cranking amps (shown in fig.2), specified by SAE and BCI, is the most frequently used value for starting a vehicle at
0°f (-18°c).
bci: Battery council international standard.
Mca: marine cranking Amps standard, effective starting current value at 0°c.
ca: cranking Amps standard, effective starting current value at 0°c.
Jis: Japan industrial standard, displayed on the battery as a combination of the numbers and letters e.g. 55d23, 80d26.
DiN: German Auto industry committee standard.
iec: internal electro technical commission standard.
eN: european Automobile industry Association standard.
sae: society of Automotive engineers standard.
gb: china national standard.
select input
ccA
rating range as following:
Measure standard
ccA
Bci
cA
mcA
Jis
din
iec
en
sAe
GB
input correct test standard and rating, press enter key. the tester begins the test, 'testinG' is displayed.
setting rate
500
ccA
it takes approximately 3 seconds to display the battery test result.
battery test result
Battery test result has 1 of 5 outcomes:
good battery
Healthy: 96%
charge 98%
internal R=24.66mΩ
rated:125A
Good BAtterY
the battery is oK to use.
good, recharge
Healthy: 78%
charge 30%
internal R=37.2mΩ
rated:125A
Good recHArGe
the battery is good but has low current, recharge before using.
© Jack sealey limited
Measure range
20-300
20-300
20-300
20-300
26A17-500d20
20-200
20-200
20-300
20-300
20-200
110ccA
12.54V
80ccA
11.20V
Original Language Version
mc105 | issue:1 23/11/16
Advertisement
