Dinner Plate; Memory Function - Master Chef EM720CNF-PM Instruction Manual

.
12

DINNER PLATE

a) Press "DINNER PLATE" repeatedly until the number you wish appears in the
display: "9.0","12.0","18.0" will display in order.
For example, press "DINNER PLATE" once, and "9.0" appears.
b) Press "START/+30 SEC." to cook, and the buzzer will sound once. When cooking is
finished, the buzzer will sound
.
13 PIZZA
a) Press "PIZZA" repeatedly until the number you wish appears in the
display: "4.0","8.0","14.0" will display in order.
For example, press "PIZZA" once, and "4.0" appears.
b) Press "START/+30 SEC." to cook, and the buzzer will sound once. When cooking is
finished the buzzer will sound five times and then turn back to the waiting state.

14. MEMORY FUNCTION

(1) Press "0/MEMORY" to choose memory en-dash procedure. The LED will display "1", "2",
or "3", depending on the number of times you press.
(2) If the procedure has been set, press "START/+30 SEC." to use it. If not, continue to
set the procedure. Only one or two stages can be set.
(3) After finishing the setting, press "START/+30 SEC." once to save the procedure and
turn back to the waiting state.If you press " START/+30 SEC." again, it will start cooking.
Example: to set the following procedure as the second memory, that is memory 2,
to cook the food with 80% microwave power for 3 minutes and 20 seconds,
the steps are as follows:
a. In waiting state, press "0/MEMORY" twice; the screen will display "2".
b. Press "TIME COOK" once, then press "3","2","0" in order.
c. Press "POWER" once, "PL10" will display, then press "8" and "PL8" will display.
d. Press "START/+30 SEC." to save the setting. The buzzer will sound once then turn back to
the waiting state. If you press "START/+30SEC." again, the procedure will be saved as
Memory 2 and operated.
e. If the electricity is not cut off, the procedure will be permanently saved. If power is cut off,
the saved procedure must be reset.
f. If you want to run the saved procedure, in waiting state, press "0/MEMORY" twice;
and the screen will display "2", then press "START/+30SEC." to run.
five times and then turn back to the waiting state.
EN-13