Installation - Dean MF90 Series Parts Manual

3. INSTALLATION:

3.1 GENERAL:
before each use, remove all loose parts from
the filter, wash the filter pan and all
accessories in hot, soapy water and dry
thoroughly.
3.2 ASSEMBLING THE FILTER:
The MF90 Filter uses a filter support grid,
filter paper and a hold-down ring to secure
the filter paper in place.
Filter Paper Configuration:
a. Figure 3-1 shows the proper assembly of
these parts:
1. Filter Pan Cover
2. Hold-Down Ring
3. Filter Paper (2 sheets)
4. Screen/Support Grid
5. Filter Pan Assembly
b. First, place the support grid in the bottom
of filter pan.
c. Put two filter paper sheets on top of the
support grid. Be sure the paper covers the
whole filter pan bottom.
d. Position the hold-down ring on top of the
filter papers and latch the hold-down ring
and filter papers securely against the filter
pan bottom, forming a tight seal.
e. Sprinkle 16 ounces of filter powder on the
top filter sheet. Ensure that the powder
covers the filter paper evenly.
f. Place the crumb catcher screen (if used)
in the filter pan. Allow the crumb catcher
to rest on the top edges of the hold-down
ring.
g. Place filter pan cover onto the filter pan
assembly.
h. Position filter underneath the fryer drain
pipe for gravity drain operations, or
nearby for suction operations.
On initial installation and
DO NOT RUN WATER THROUGH
THE FILTERING SYSTEM. THE
FILTER PUMP IS NOT DESIGNED
TO HANDLE WATER. THIS WILL
VOID THE WARRANTY FOR
THAT SYSTEM, DAMAGE THE
PUMP AND CAUSE ACCIDENTS
IF WATER MIXES WITH HOT
OIL.
2
4
5
4
WARNING!
Figure 3-1
1
3