Page 1
Manual Cablehandset Rev 1 – 08/2007 Availability and specifications are subject to change without prior notice. LOGICDATA assumes no liability for maloperation or improper use of products. LOGICDATA will at point of delivery replace/repair defective products covered by the warranty.
Information: For definitions and information concerning LOGICDATA Control boxes please refer to the applicable manual. Aside of moving your table up and down your LOGICDATA control box is able to carry out other functions, like controlling the brightness of a lamp or a monitor –...
2.3 Functionality HSF The HSF - Cablehandset offers following functionality: Ultra - flat design • Big and comfortable to use buttons • New info display with status information • Display of 1/10 inch or cm • soft click button feeling •...
Danger: Use only genuine replacement parts! Repairs must be carried out only by a qualified service technician! If you neglect to do so you void your warranty! 2.5 Overview desk / 2nd desk upwards motorgroup upwards position button 1 desk position button 3 downwards desk / 2nd motorgroup...
Color code: handset ... blue motor ... black 3 Mounting Instructions Mount the HSF - cablehandset underside your desktop in an appropriate position. Following tools are required for installation: • 1 screw driver Please take note, that the handset is equipped with a shift mechanism. Therefore always mount the handset in a drawn in position.
45329, 7 – pin) only! Do not connect the handset plug to the motor jacks!! Caution: Unplug the power cord while mounting the LogicS control box! Pict. 2 – Connect the HSF - cablehandset to the control box (e.g. LOGIC S) 4 Functions The HSF –...
4.2 Information LED’s Note: Please refer to your control box manual for further information regarding the functions mentioned below Container – LED This LED shows that the Containerstop function is active. Reset – LED This LED shows that the control box is being reseted. Flex –...
4.3 Basic Functions Note: In case of no motorgroup 2 attached the therefore assigned buttons (motorgroup 2 upwards / motorgroup 2 downwards) are used for the desk upwards / desk downwards functions. Function Description Note For an upward adjustment of The desk will continue driving Desk upwards...
4.4 Advanced Functions 4.4.1 Storing a position Using this function you are able to store a desk-height. Note: On initial operation all stored positions are equal to the lowest possible desk-height (lower end position). Note: Only one desk-height per button is allowed. Move the desk to the position you want to store.
Alternative B (using double click automatic function) Note: If the double click function is available depends on the configuration of your control box. Double-click the desired position button (e.g. 2) The desk automatically moves to the saved position. If you press any button before reaching the saved position, the desk stops and the saved position will not be reached.
Cable is defect Contact our customer service 5.2 Continuative Information Final Disposal Please heed following disposal instructions when disposing of the HSF - cable handset: Note: Dispose of the components ecologically sound (separate plastic from electronics parts)! 6 Manufacturer information LOGICDATA Tel.: +43 (0)3462 5198 0...