Advertisement
4P1000 Pro-Cell Partition
I.
Refer to the diagram on the last page of these instructions to verify all parts were received.
II.
The following tools will be required to complete the installation.
A. 1/4" or 3/8" drive ratchet with 3/8", 7/16", 7mm, 10mm, 18mm, socket
B. 3/16" Allen key
C. 1-1/2" Hole saw
D. Drill with 3/8" Socket
E. T15 Torx Driver
III.
Read all instructions carefully before starting the assembly process.
Caution:
Locate all Wiring, Fuel Lines, Brake Lines, and/or Cooling Lines before drilling holes or installing Fasteners.
IV.
Removing the OEM Trim Panels
A. Remove B-pillar trim on the Driver and Passenger-side. These will be reinstalled after
bracket installation. Note: From the head liner down the trim is held in place by
snap fasteners but the top of the trim panel is held in place with a screw. Pull head liner
down and away from the trim panel and use a T15 torx driver to remove the screw.
(See Fig. 1)
Fig. 1
PASSENGER SIDE SHOWN
B-PILLAR TRIM
pro-gard.com
800.480.6680
THESE COMPONENTS ARE REQUIRED
TO INSTALL THE PRO-GARD PRO-CELL SYSTEM
4K56C11 Partition Kit
4K56C11 Partition Kit
4S56C11 Seat Kit
B. Remove the Rear Door Scuff Plates on the
Driver and Passenger-side. These will be
reinstalled after the ABS Floor Pan Installation.
(See Fig. 2)
WB56C11 WB & DP
3P5615 Divider
2
S56C11 Seat
FP56C11 Floor Pan
Fig. 2
PASSENGER SIDE SHOWN
REAR DOOR
SCUFF PLATE
Advertisement
