Summary of Contents for Pro-gard Products LLC. P1000 Pro-Cell
- Page 1 INSTALLATION GUIDE P 1 0 0 0 P RO - C E L L 2 0 1 5 D O D GE C H A R GE R S T R O N G R E L I A B L E S E C U R E pro-gard.com 800.480.6680...
- Page 2 THESE COMPONENTS ARE REQUIRED TO INSTALL THE PRO-GARD PRO-CELL SYSTEM 4K56C11 Partition Kit S56C11 Seat WB56C11 WB & DP 4K56C11 Partition Kit 4P1000 Pro-Cell Partition 4S56C11 Seat Kit 3P5615 Divider FP56C11 Floor Pan Refer to the diagram on the last page of these instructions to verify all parts were received. The following tools will be required to complete the installation.
- Page 3 Removing the OEM Seat Fig. 3 DRIVER SIDE SHOWN A. Begin by lifting the lower seat cushion out from the rubber grommets in the floor. Once the seat is free remove from the vehicle (See Fig. 3). B. Remove the seat belts by removing the OEM nuts from their mounting studs. Do not remove the shoulder straps anchored at each side of the vehicle.
- Page 4 E. Secure the outside front corners of the seat by Fig. 6 using the supplied 5/8” long self-tapping screws 3X36 PASSENGER SIDE SHOWN (3X177) and finish washers (3X78) at each end of the seat near the C-pillar trim using the pre-drilled holes provided in the seat. 3X36 Note: The gas tank is under the rear seat in this vehicle.
- Page 5 Fig. 9 Passenger-side trim panel, carfully align the Template PASSENGER SIDE SHOWN per their included instructions. Using a 1” Hole Saw drill the clearance holes as marked on the template. B-PILLAR TRIM Replacment of sound insulation is optional. 3PRT5611-01P B. Replace the trim panel, insureing that the standoff’s protrude through the panel.
- Page 6 B. Insert the center divider from the passenger side of the vehicle. Be sure to start with the tail of the divider, aimed toward the rear window and speaker deck area. Once you have inserted the divider, press the divider against the seat mount brackets, and then to the partition tabs Mark all mounting hole locations on the divider with a felt tip marker then remove the divider for drilling or drill in place if desired.
- Page 7 pro-gard.com 800.480.6680...