Advertisement
6.
To position chute attachment on Model SP-1, remove wing nuts
from the studs on back of splitter. Insert top of bag loading chute
over support angles that normally hold material pan, fitting holes
over threaded studs. Replace wing nuts. With bag-tightening
lever in horizontal position (right or left), draw top of bag over
sharp corners of chute bottom and reverse fold bag on top of
bag-tightening lock tab. Lift lever to secure bag.
SP-2.5 ONLY:
Two position stop is used on hopper gate lever. When in Position 1, safety stop holds hopper open during cleaning or bar adjustment.
Position 2 controls the maximum amount hopper can open. Failure to utilize this stop may allow material to feed outside of chute area.
POSITION 1
POSITION 2
SAFETY STOP (HOLDS HOPPER OPEN)
LEVER STOP (CONTROLS HOPPER MAXIMUM OPENINGS)
7.
Models SP-0, SP-2.5, SP-3, and SP-33 are manufactured with
60° chute slopes as required for coal or coke (ASTM D 2013,
D 346) or for other materials requiring steep slope for proper
sample flow. Other models may be easily changed to 60° from
standard 45° chute slopes by adding the following adapter kits
in the field:
Kit for SP-1
Model SPA-103
Kit for SP-2
Model SPA-106
Advertisement
