Mcube MC3672 Quick Start Manuals page 7

MC3672 Accelerometer Driver
2.2 SPI INTERFACE
The EV3672A evaluation board can be easily wired to any microcontroller. This example
shows a typical Arduino UNO platform. Please refer to the illustration below for connecting the
related pins and then port the code to get the raw X, Y, Z sensor data.
•
Connect DVDD to the power supply, 3.3V. (Providing higher voltage, like 5V may
damage the sensor.)
•
Connect GND to common power/data ground.
•
Connect SCL to digital I/O pin 13 as Serial Clock.
•
Connect SDO to digital I/O pin 12 as Master Input, Slave Output.
•
Connect SDA to digital I/O pin 11 as Master Output, Slave Input.
•
Connect SCS to digital I/O pin 10 as Slave Select.
mCube Proprietary.
© 2018 mCube Inc. All rights reserved.
APS-045-0017v1.2
Quick Start Guide and Demo
7 / 19