Sony MDR-EX51LP Operating Instructions

Stereo earphones

Operating Instructions

使用說明書
使用说明书
사용설명서
MDR-EX51LP
© 2006 Sony Corporation
A
B
C
D
2-691-325-21(1)
Printed in China
English

Specifications

Type: Closed, dynamic / Driver units: 9 mm (CCAW adopted), dome
type / Power handling capacity: 100 mW (IEC*) / Impedance: 16 Ω
at 1 kHz / Sensitivity: 100 dB/mW / Frequency response: 6 –
23,000 Hz / Cord: Approx. 1.2 m (47
Gold-plated stereo mini plug / Mass: Approx. 4 g (0.14 oz.) without
cord / Supplied accessories: Earbuds (S × 2, M × 2, L × 2), Holder (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
How to use
Wear the earpiece marked R in your right ear and the one marked L
in your left ear.
How to use the holder
Store the housing part as in illustration A. It prevents the cord from
becoming tangled if you store the ear receiver connected to a device
such as WALKMAN in your pouch or bag. When using the
earphones, you can adjust the cord length by winding the cord around
the holder, as in illustration B.
How to install the earbuds correctly
(See. Ill. C)
If the earbuds do not fit your ears correctly, low-bass sound may not
be heard. To enjoy better sound quality, adjust the earbuds position to
sit on your ears comfortably or push them into the inside of your ears
so that they fit your ears snugly. If the earbuds do not fit your ears,
try ones of other size.
Cleaning the earbuds
Remove the earbuds from the earphones, and wash them with a mild
detergent solution.
Precautions
• Please keep your earphones clean at all times especially inside the
rubber earbud (see. Ill. D).
If any dust or ear wax inside the earbud, you may experience some
listening difficulties.
• Listening with earphones at high volume may affect your hearing.
For traffic safety, do not use while driving or cycling.
繁體中文
規格
型式：封閉式，動態 / 激勵單元：9 mm (採用 CCAW)，圓頂型 /
功率處理容量：100 mW (IEC*) / 阻抗：1 kHz時 16 Ω / 靈敏
度：100 dB/mW / 頻率響應：6 - 23000 Hz / 導線：約 1.2 m
的 OFC 線材 / 插頭：鍍金立體聲迷你插頭 / 質量：約 4 g
(不含導線) / 附件：耳塞 (S × 2, M × 2, L × 2)，固定座
(1)
* IEC = 國際電工委員會
設計和規格如有變更，恕不另行通知。
使用方法
將有 R 標記的耳機戴在右耳， L 標記的耳機戴在左耳。
使用固定座的方法
如圖A所示放置耳機部件。如果您將連接在 WALKMAN 等裝置
的耳機放於保護袋或包中，此方法能預防耳機線糾結在一起。
使用耳機時，如圖B所示，您可以藉由將耳機線環繞於固定座
周圍的方式來調整耳機線長度。
正確安裝耳塞的方式 (請參閱圖C)
如果耳塞無法正確符合您的耳型，您便可能無法聽到重低音。
為了能夠享受較佳的音質，請調整耳塞的位置以舒適固定於您
的耳旁，或將耳塞推入您的耳朵內，以完全服貼您的耳朵。如
果此耳塞不符合您的耳型，請試著使用其他尺寸的耳塞。
清潔耳塞
將耳塞從耳機體上拆下，並以溫和的清潔劑溶液清洗。
注意事項
• 請隨時保持耳機的清潔，尤其是橡膠耳塞的內部
(請參閱圖D)。
如果耳機有灰塵或耳垢，您可能會無法順利聆聽音樂。
• 戴著耳機用很高的音量收聽可能會影響您的聽力。為了交通安
全，切勿在駕車或騎車時使用耳機。
1
/ in.), OFC litz cord / Plug:
4