Page 1
4. Use the finger holes to slide the template through the hole. Be sure to keep the template horizontal. If there is any interference, use a rasp to remove the interference. 5. Insert Interport into cutout. Use phillips head screwdriver to tighten locking cams snugly to the work surface. Do not overtighten.
Page 2
6. Place the cord holder approximately 12” from the Interport using the double faced tape included. Opening Size Ganging "X" Dim. Single Interport 6.00 Note: Drawing not to scale 12.00 Double Interport Triple Interport 18.00 4.50 “X” Cutout Edge R .190...