Page 1
4. Use the finger holes to slide the template through the hole. Be sure to keep the template horizontal. If there is any interference, use a rasp to remove the interference. 5. Insert Mini-Port into cutout. Use phillips head screwdriver to tighten locking cams snugly to the work surface. Do not overtighten.
Page 2
6. Place the cord holder approximately 12” from the Mini-Port using the double faced tape included. Note: Depending on the combination of coupler/jack/cord installed, it may be desirable to loosely secure the data cord to the Mini-Port latch with a tywrap to prevent potential interference.