Connections (Continued)
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the 75-ohm Coaxial
Cable supplied (R).
Note
If you use this connection, tune the TV to the
DVD+VCR's RF output channel (CH 3 or 4).
How to set the DVD+VCR's RF output channel
1. When the DVD+VCR is turned off, press and hold
CHANNEL (v/V) on the front panel for about five
seconds.
It will turn itself on and "RF03" or "RF04" appears in the dis-
play window.
2. Press CHANNEL (v/V) on the front panel or CH/TRK
(v/V) on the remote control to change the RF output
channel (CH 03 or CH 04).
3. Turn off the DVD+VCR.
Audio/Video connection
1 1
Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using the
video cable supplied (V).
2 2
Connect the Left and Right DVD/VCR AUDIO OUT
jacks on the DVD+VCR to the audio left/right in
jacks on the TV (A1) using the supplied audio
cables.
Note
If you use this connection, set the TV's source selector
to VIDEO.
Rear of TV
ANTENNA
INPUT
R
Rear of DVD+VCR
12
VIDEO
AUDIO INPUT
INPUT
R
L
A1
V
Optional, Preferred TV Connections
Note
You can ONLY watch and listen to DVD playback
through the connections shown below.
S-Video connection
1 1
Connect the S-VIDEO OUT jack on the DVD+VCR
to the S-Video in jack on the TV using the optional
S-Video cable (S).
2 2
Connect the Left and Right AUDIO OUT jacks of
the DVD+VCR to the audio left/right in jacks on the
TV using the supplied audio cables (A2).
Component Video (Color Stream
Scan (ColorStream
pro) connection
®
If your television is a high-definition or "digital ready"
television, you may take advantage of the
DVD+VCR's progressive scan output for the highest
video resolution possible.
If your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you try
Progressive Scan on the DVD+VCR.
1 1
Connect the COMPONENT / PROGRESSIVE
SCAN VIDEO OUT jacks on the DVD+VCR to the
corresponding in jacks on the TV using an optional
Y Pb Pr cable (C).
2 2
Connect the Left and Right AUDIO OUT jacks of
the DVD+VCR to the audio left/right in jacks on the
TV (A2) using the supplied audio cables.
Notes
– Set the Progressive Scan to "On" on the setup menu
for progressive scan signal, see page 18.
– When you use Component Video signal, set the
Progressive Scan to "Off" on the setup menu.
– Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack).
Rear of TV
COMPONENT / PROGRESSIVE SCAN
S-VIDEO
VIDEO INPUT
INPUT
Pr
Pb
S
C
Rear of DVD+VCR
) / Progressive
®
AUDIO INPUT
Y
R
L
A2