Subscribe to Our Youtube Channel
Related Manuals for Supreme Heating AQUAGEN 5 RT
Summary of Contents for Supreme Heating AQUAGEN 5 RT
- Page 1 AQUAGEN 5 RT CONTROLLER USER MANUAL The AquaGen 5RT Controller is designed for systems where the solar is plumbed into the existing pool plumbing and operates the filter time-clock and solar pump.
-
Page 2: Installation Instructions
14/020 should be used. Any cable joins should be soldered. Heat shrink is to be used over soldered joints to eliminate moisture ingress, and the cable end is to be refitted to the plug sockets. Once cables have been correctly fitted the unit can be then turned on. AquaGen 5 RT Controller... -
Page 3: Lcd Screen
Solar Manual is for testing the solar pump installation on a cold or cloudy day. Once manual mode is selected the pump will start. After manual mode time-outs, unit will return to the previous mode. The factory default for SOLAR MODE is Heating MODE AquaGen 5 RT Controller... -
Page 4: Enter Button
Twice per day FILTER CYCLE 2 menu: FILTER CYCLE 1 FILTER CYCLE 2 xx:xx TO xx:xx xx:xx TO xx:xx Adjust the start time and end time for the required filter cycle(s), the circulation pump will run between these times for filtration purposes. AquaGen 5 RT Controller... - Page 5 Press ENTER on this menu to return to automatic operation. SET CLOCK Allows you to adjust calendar date and time of day. LCD TIME Adjust the number of seconds the backlight remains on after the time a button was pressed. (Select NONE for always on.) AquaGen 5 RT Controller...
-
Page 6: Installer Setup
POOL SENSOR POOL ROOF SENSOR SOLAR COLLECTOR RETRO / INTEGRATED CONFIGURATION IONISER CONTROLLER SOLAR PUMP FILTER FILTRATION PUMP IONISER POOL SENSOR CELL POOL Warn the customer not to change from series retro-fit as damage may occur AquaGen 5 RT Controller... - Page 7 You have the option to select a ‘LIVE’ sensor, select YES for a commercial USE LIVE SENSOR? system where the pool sensor is in constant water flow, selecting NO NO/YES (recommended) will turn on the sampling feature where the controller assumes that pipe temperature is not always pool temperature. AquaGen 5 RT Controller...
- Page 8 For use when Heatseeker UniPanels cannot drain down and will require ® NO/YES a wetted roof sensor for this mode CALIBRATE POOL SENSOR BY: X.X This is for the + series sensor only (TS02P) (RANGE -5.0 TO +5.0°C) AquaGen 5 RT Controller...
- Page 9 Maximum combined rated output load for the 240V socket(s) is 9.98 Amps / 2395 Watts. Degree of protection against moisture: IP33. Store pool chemicals at least 3 metres safely away from all pool equipment. AquaGen 5 RT Controller...
-
Page 10: Warranty
Warranty does not include on-site labour or travel costs to or from installation site. If the power cord is damaged, do not use the controller; return the unit to the supplier for repair. CUSTOMER RECORD (TO BE RETAINED BY THE CUSTOMER) Dealer/Installer Name Serial Number Date Installed AquaGen 5 RT Controller... - Page 11 AquaGen 5 RT Controller...
- Page 12 2/19 Enterprise Drive, Bundoora, Victoria 3083 Phone: 1300 787 978 Email: info@supremeheating.com.au...
Need help?
Do you have a question about the AQUAGEN 5 RT and is the answer not in the manual?
Questions and answers