Related Manuals for Supreme Heating AquaGen 5
Summary of Contents for Supreme Heating AquaGen 5
- Page 1 AquaGen 5 Controller User Manual The AQAUGEN 5 is a premium automatic solar controller with temperature adjustment, manual, cooling and standby mode features. N A T I O N A L...
-
Page 2: Installation Instructions
14/020 should be used. Any cable joins should be soldered. Heat shrink is to be used over soldered joints to eliminate moisture ingress, and the cable end is to be refitted to the plug sockets. Once cables have been correctly fitted the unit can then be turned on. AquaGen 5 Controller... -
Page 3: Mode Button
Due to rounding the actual heat may vary by up to ±½°C. The ability to solar heat the pool will depend on weather conditions. The factory default for SOL. LIMIT is 30°C AquaGen 5 Controller... -
Page 4: Enter Button
The LCD screen displays the pool and roof temperatures, solar temperature limit, pump on status, on/off/locked-out status and the time of day & date (clock). LCD Indicators There are arrow icons on the LCD screen that point to current mode text on the label. AquaGen 5 Controller... -
Page 5: Controller Troubleshooting
If the controller reports a short circuit, then the cable is fine and you may replace the sensor end if re-routing a new cable is not possible. If the controller reports a short circuit while the cable is unplugged, then the controller requires repair. AquaGen 5 Controller... - Page 6 This can occur if the unit has been turned off for a prolonged period of time. Leave the unit on RTC-FAIL for 30 seconds and this will allow charging of the supercapacitor. Next, turn it off for 30 seconds before turning it back on. AquaGen 5 Controller...
-
Page 7: Installer Setup
5. Maximum combined rated output load for the 240V socket(s) is 9.98 Amps / 2395 Watts. 6. Degree of protection against moisture: IP33. 7. If the power cord is damaged, do not use the controller; return the unit to the supplier for repair. AquaGen 5 Controller... -
Page 8: Warranty
Warranty This range of product is covered by a limited 3 year warranty against component failure or faulty workmanship from the date of installation. Faulty units should be returned in the first instance to the dealer from which the unit was purchased (return to base).
Need help?
Do you have a question about the AquaGen 5 and is the answer not in the manual?
Questions and answers