Advertisement
-Use existing nut if it is available
-Install rack on to side assemblies using
(6) - 1/4" – 20 X 3/4" Hex Flange Bolt
(6) - 1/4" Nylock Flange Nut
-Do not fully tighten, keep the rack slightly loose. This will
give a little play with installation on unit.
-Starting from the top of the rack and moving down,
tighten all loose bolts
The following are general instructions for installation of
the Polaris RZR
570/800 Expedition Rack
®
"Tailgate" . It is the up to the installer that each rack be
securely mounted.
-Install latch plate using
(2) - 1/4" – 20 X 3/4" Hex Flange Bolt
(2) - 1/4" Nylock Flange Nut
See Fig. 8
WARNING
-- CAUTION Loads must be equally distributed
- Operator must use common sense when loading rack so as not to
affect the vehicles safe operation
- It Is The operators responsibility to follow all manufactures
recommendations regarding safe operation of any vehicle
RAZORBACK OFFROAD
™
(RBO5140)
™
RBO suggests
using the inner
most slot
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Advertisement
