Table of Contents
Advertisement
INSTALLATION
Tabs
Screwdriver
6. Reconnect the wire harness and the
antenna and be careful not to pinch
any wires or cables.
7. Slide the unit into the sleeve until it
locks into place.
8. To further secure the unit, use the
supplied metal strap to secure the back
of the unit in place. Use the supplied
hardware (Hex Nut (M5mm) and Spring
Washer) to attach one end of the strap
to the mounting bolt on the back of
the unit. If necessary, bend the metal
strap to fit your vehicle's mounting
area. Then use the supplied hardware
(Tapping Screw (5x25mm) and Plain
Washer) to attach the other end of
metal strap to a solid metal part of the
vehicle under the dashboard. This strap
also helps ensure proper electrical
grounding of the unit.
Spring Washer
Metal Strap
Mounting Bolt
9. Reconnect the cable to the vehicle
battery's negative (-) terminal. Then
replace the outer trim ring.
Dashboard
Removing the unit
1. Make sure the ignition is turned off,
and then disconnect the cable from
the vehicle battery's negative (-)
terminal.
2. Remove the metal strap attached the
back of the unit (if attached).
3. Lift the top of the outer trim ring then
pull it out to remove it.
4. Insert both of the supplied keys into
Sleeve
the slots at the middle left and right
sides of the unit, then pull the unit out
of the dashboard.
Hex Nut
Plain Washer
Tapping Screw
7
Advertisement
Table of Contents
