Radio Operation - Sanyo ECD-T1580DV Owner's Manual

OPERATION
button repeatedly can select three kinds
of repeat play modes.
REP-ONE:
Play the same song over and over again.
FOLDER REP:
Play all songs in the current directory in
sequence, over and over again.
FOLDER:
Play all songs in the current directory
once.
When select PLAY MODE, press
to change between the following mode:
SINGLE REP-ONE FOLDER
DISC SCAN DISC DISC REP
SHUFFLE ON PROGRAM PXXX
During playback, use
item ahead or back.
: Rapid r everse, : Rapid advance
Note: The FOLDER cannot be selected
during playing. It can be selected after
(Stop) button pressed.

RADIO OPERATION

Switching to radio mode
Press MODE button on remote
control to select radio mode.
In radio mode, the following
information will appear on the display.
FM1 98.1 MHz
MONO
VOLUME 40
BASS -2
TREBLE -2
BALANCE L-R
FADER F-R
LOUD OFF
EQ POP
Selecting the frequency band
Press BAND on remote control to
select desired band. The reception
band will change in the following
order:
FM1 FM2 FM3
Selecting station
During radio mode, press CH
on remote control to increase
frequency or CH
control to decrease frequency by one
step of channel spacing. Hold the
button longer for fast tuning. The
frequency is updated correspondingly
on display.
Setting memory
Press RADIO PRESET buttons (1~6)
/
on remote control to preset stations
at radio mode. With this system, a
FOLDER REP
total of 30 stations can be stored in
RANDOM
the memory of six buttons. Each
band stores up to six preset stations.
or to skip an
The stations might be FM1, FM2,
FM3, AM1 and AM2 band.
The operation is as below:
- Store in Memory
- Retrieve a Preset Station
M1 87.50
Automatic memory storing &
M2 90.10
program scanning
M3 98.10
- Automatic memory storing
M4 106.10
M5 108.00
M6 87.50
- Program scanning
AM1 AM2
25
button on remote
Press and hold desired
memory location button for
several seconds. The current
listening station will be stored
into the number button.
Press any one of the RADIO
PRESET buttons (1~6) on
remote control to retrieve a
station which had been stored
in the memory in advance the
chosen number is shown on
display.
Press GOTO (AS/PS) button
on remote control for several
seconds, the radio searches
from the current frequency and
checks the signal strength until
one cycle search is finished.
And then 6 strongest stations
are stored into the
corresponding preset number
button.
Press GOTO (AS/PS) button
on remote control shortly to
scan preset station.
button