Huawei RRU3201 Installation Manual page 19

RRU3201
Installation Guide
Label
ALM
TX_ACT
VSWR
CPRI_W
CPRI_E
Issue 06 (2012-04-16)
Color Status
Steady off
Blinking (on for
1s and off for 1s)
Blinking (on for
0.125s and off for
0.125s)
Red Steady on
Blinking (on for
1s and off for 1s)
Steady off
Green Steady on
Blinking (on for
1s and off for 1s)
Red Steady off
Steady on
Blinking (on for
1s and off for 1s)
Blinking (on for
0.125s and off for
0.125s)
Red and Steady green
green
Steady red
Blinking red (on
for 1s and off for
1s)
Steady off
Red and Steady green
green
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Information About the Installation
Description
There is no power supply, or the module is
faulty.
The module is working properly.
Software is being loaded to the module, or the
module is not started.
Alarms are generated, and the module must
be replaced.
Alarms are generated. The alarms may be
caused by the faults on the related boards or
ports. Therefore, the necessity for module
replacement is uncertain.
No alarm is generated.
The module is working properly with TX
channels enabled.
The module is working properly with TX
channels disabled.
No VSWR alarm is generated.
VSWR alarms are generated on the ANT-
TX/RXA port.
VSWR alarms are generated on the ANT-
TX/RXB port.
VSWR alarms are generated on the ANT-
TX/RXA and ANT-TX/RXB ports.
The CPRI link is available.
An optical module fails to transmit or receive
signals because the optical module is faulty
or the fiber optic cable is broken.
The CPRI link is out of lock because of
mutual lock of dual-mode clock sources or
mismatched data rates over CPRI ports (you
are advised to check the system configuration
to identify the fault).
The SFP module is not properly installed, or
the optical module is powered off.
The CPRI link is available.
11