Do not store or operate outdoors. If electrical wiring or components become wet, thoroughly dry them before using the unit. If in doubt do not use the dehumidifier and consult a qualified electrician or a Meaco approved engineer.
Page 3
UK plug wiring Wiring Instructions: Should it be necessary to change the plug please note the wires in the mains lead are coloured in accordance with the following code: BLUE - NEUTRAL BROWN - LIVE GREEN AND YELLOW – EARTH As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1.
1. GENERAL ADVICE Before putting your dehumidifier into operation for the first time, the instruction manual should be studied carefully. After receiving the unit, you should check your dehumidifier for any transport damage. In case of damage, you should inform the sender immediately. Keep the packaging for the dehumidifier in a safe place in order to be able to despatch the dehumidifier safely if it requires a service.
For transportation the dehumidifier should be secured on a level base and must be prevented from rolling around. The dehumidifier must always be transported vertically. This dehumidifier must be used exclusively for drying the air. If the dehumidifier has been in a horizontal position for any period of time more than a couple of few minutes, then you must let it stand in the upright position for at least 30 minutes before operating.
6. CONTROL PANEL Turning the dehumidifier On or Off When you plug the dehumidifier in it will bleep and two dashes will appear on the display. Press the Power button to turn the dehumidifier on. When you press Power again to turn the dehumidifier off the fan will run for ten seconds before the machine turns off.
Fan Speed Allows you to select one of two fan speeds. In high fan speed the indicator light is red, in low fan speed it is blue. Display The display will show the current relative humidity whilst running. If you press the target button it will first show you the set point that it is working to.
This dehumidifier can be operated within an ambient temperature range from +5°C to +35°C and with a relative humidity from 30% to 90%rh. It is suitable for applications in domestic situations and in museums and archives. 11. SPECIFICATIONS Model Meaco 12-AH Temperature Range +5 °C / +38°C Relative Humidity Range...
This is normal and is not a fault. appears on the display, The fan is not running Fan not running Contact a Meaco approved workshop. Assure that the device is only set up in The room temperature is lower than +5ºC rooms with temperatures above +5°C.
13. MAINTENANCE Always turn off the power and disconnect the main cable before performing maintenance procedures. All service procedures below are to be executed with the unit unplugged. Perform before each use or as needed. INSPECT ELECTRICAL SYSTEM: Inspect the electrical cord for damage at regular intervals. The working performance of the dehumidifier will be greatly reduced if the carbon filter is blocked with dust.
…………………………………………………….. Meaco are specialists in dehumidifiers and would welcome your comments and questions on this dehumidifier. If you do develop a fault within the first year then please do call us and if we cannot fix the problem over the phone we will be happy to collect the dehumidifier from you at our expense and repair or replace as appropriate.
Need help?
Do you have a question about the 12L-AH and is the answer not in the manual?
Questions and answers