Bosch Lambdatronic LT4 ADV Quick Start Manual page 6

3 | Calibration and Live Data Viewing/Recording
3.2.1
6 / 12
types can also be viewed in an oscilloscope; this can be done by right‐clicking on
the desired variable and selecting the option "New oscilloscope". If you wish to
create multiple sheets within the workfolder, right‐click in the worksheet tab area
and select "New".
Loading the Pre‐Made Workfolder
Included in the LT4 ADV project folder is a workfolder file with pre‐made work‐
sheets. These have been configured with the most important variables to enable
quick calibration and data viewing. To load this workfolder, select the tab "Work‐
folder/Worksheets" at the top of the ModasSport window and select the "Open"
button in the "Workfolder" section of the ribbon:
The "Open workfolder file" dialog should automatically open the folder "CON‐
FIG" within the LT4 ADV project folder. If this does not happen, navigate to your
LT4 ADV project folder directory and open the folder "CONFIG". Once here, se‐
lect the file "LT4 ADV.mxwf":
The worksheet area should now be populated and two worksheet tabs should
appear in the lower left corner of the area. The sheet "Monitor" will allow you to
monitor sensor status, sensor readings, and LT4 ADV communication. The sheet
"Parameter Settings" will allow you to perform calibration and device setup tasks.
Lambdatronic LT4 ADV Bosch Motorsport