RIKA is always ambitious to provide an excellent service. Have a good time, enjoying the cosy warmth of your RIKA stove as often as Note you wish. The appliance may only be put into operation if fully assembled! RIKA Innovative Ofentechnik GmbH Before your appliance is energised for the first time, the flash drive...
INITIAL PHASE, the display will switch to BURN OFF only after a few minutes. SETTINGS Setting: Heating times, Multi-air, frost protection, RIKA Cleaning function room sensor, ... In addition to the standard functions, stove models with an automatic grid dispose of a cleaning function.
Opening the ROOM SENSOR decorative glass door only with RIKA room sensor / RIKA radio room sensor ECO function In addition to the standard functions, some combi stoves dispose of an ECO function. only with RIKA GSM Controlo...
The stove may only be started in the STANDBY operating state. In the operating state STOVE OFF it is not possible to start up the stove. Note The comfort mode may only be selected if a RIKA room sensor is connected.
Tu 17.10.2017 15:55 For more information on this option, please consult the operating instructions room sensor / RIKA radio room sensor. If there is a room sensor built in you get access to temperture adjustment and power Heating Times requirement.
Current firebox temperature Main operating regulation state Room temperature [°C] Sub State ACTUAL temperature in the room Secondary operating regulation state only with RIKA roomsensor Stove type Ext. Request External request enabled (ON) or disabled (OFF) Name of appliance Pressure switch Software stove Sufficient low pressure in the firebox to ensure operation (ON),...
firelighter. Note The ECO OPERATION mode is only possible after the first burn-off! Now set the RIKA firelighter (or the uncoated paper) alight and close the firebox door. Note Be sure that the combustion trough is empty as the grid will tip...
Log operation in case of power breakdown Combined operation Automatic ignition of firewood during start-up, or automatic log Note recognition during operation. Your stove must be disconnected from the mains for current-free Automatic ignition of firewood during start-up operation. Place two logs into the firebox. Be sure that at least one of the logs lays above the combustion trough to facilitate burning.
8. NOTES, WARNINGS AND ERROR MESSAGES To ensure trouble-free functioning, your stove is equipped with a number of safety devices. Notes NOTE NOTE NOTE PLEASE PERFORM BATTERY EMPTY AIR FLAPS CLEANING OR DEFECTIVE ON CALIBRATION Note Please wait The mainboard battery is empty or After each power failure the air flaps Meaning A unit cleaning is required.
Error messages If an error occurs, your stove switches over to the operating state BURN-OFF. After the appropriate measure has been taken, your stove is ready for operation again. Note If the error messages appear again and again, please contact the customer service without delay. ERROR #00 ERROR #01 ERROR #02...
Page 13
ERROR #11 ERROR #11 ERROR #12 BURNBACK AND FLUE GAS FLAP OPEN DEFECT FLUE GAS FLAP Error Burn-back flap and flue gas flap are not The flue gas flap is not in heating Prescribed speed of the flue gas fan is Meaning in heating position.
Need help?
Do you have a question about the V2.23 and is the answer not in the manual?
Questions and answers