RIKA is always ambitious to provide an excellent service� Have a The appliance may only be put into operation if fully assembled! good time, enjoying the cosy warmth of your RIKA stove as often as you wish� Before your appliance is energised for the first time, the flash drive...
Range: Manual mode, automatic mode and comfort minutes� mode Cleaning function SETTINGS Setting: Heating times, Multi-air, frost protection, RIKA In addition to the standard functions, stove models with an automatic room sensor, ��� grid dispose of a cleaning function� INFO Display: flame temperature, total operating hours, total ignitions, software version,���...
Standard function Opening the ROOM SENSOR decorative glass door Only with RIKA room sensor / RIKA radio room sensor ECO function In addition to the standard functions, some combi stoves dispose of an ECO function� Only with RIKA GSM Control...
The stove may only be started in the STANDBY operating state� In the operating state STOVE OFF it is not possible to start up the stove� Please note The comfort mode may only be selected if a RIKA room sensor is connected�...
Su 16.10.2016 15:55 For more information on this option, please consult the operating instructions room sensor / RIKA radio room sensor� If there is a room sensor built in you get access to temperture adjustment and power requirement� Heating Times Temperture adjustment It is possible to adjust the temperature shown in the infomenu�...
6. INFO In the main menu INFO you can retrieve the most important Parameters parameters� Info 15:55 Su 16.10.2016 Operat. hours pellets Total operating hours in pellet mode (0 - 99999) Feed rate total [kg] Input Total pellet feed volume (0 - 99999) Kg till cleaning Output Remaining pellets feed volume until next cleaning (1500 - 0)
Please note The ECO OPERATION mode is only possible after the first burn-off! Now set the RIKA firelighter (or the uncoated paper) alight and close the firebox door� Please note Be sure that the combustion trough is empty as the grid will tip after the firebox door has been closed�...
Current-free log operation Combined operation Automatic ignition of firewood during start-up, or automatic log Please note recognition during operation� Your stove must be disconnected from the mains for current-free Automatic ignition of firewood during start-up operation� Place two logs into the firebox� Be sure that at least one of the logs lies above the combustion trough to facilitate burning�...
8. NOTES, WARNINGS AND ERROR MESSAGES To ensure trouble-free functioning, your stove is equipped with a number of safety devices� Notes NOTE NOTE NOTE PLEASE PERFORM BATTERY EMPTY AIR FLAPS CLEANING OR DEFECTIVE ON CALIBRATION Please note Please Wait A unit maintenance or a cleaning cycle The mainboard battery is empty or After each power failure the air flaps Meaning...
Error messages If an error occurs, your stove switches over to the operating state BURN-OFF� After the appropriate measure has been taken, your stove is ready for operation again� Please note If the error messages appear again and again, please contact the customer service without delay� ERROR #00 ERROR #01 ERROR #02...
Page 13
ERROR #11 ERROR #11 ERROR #12 BURNBACK AND FLUE GAS FLAP OPEN DEFECT FLUE GAS FLAP Error Burn-back flap and flue gas flap are not The flue gas flap is not in heating Prescribed speed of the flue gas fan is Meaning in heating position�...
Need help?
Do you have a question about the V2.23 and is the answer not in the manual?
Questions and answers