Konan Labs KLT-150RG-6 User Manual

Manual Mode

Access the five different operating modes available in this fixture by using the
<WORK MODE> button on the front panel.
Press < WORK MODE > to cycle through the modes. Please see a description of each mode below.
Mode Description
1 Sound-active A
2 Sound-active B
3 Automatic A (constant rotation-slow)
4 Automatic B (stepping rotation-back and forth)
5 Automatic C (constant rotation-fast)
* The LED indicator on the front of the fixture will be green when a sound-active mode
is selected.
*The LED indicator on the front of the fixture will be red when an automatic mode is selected
Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work, please check
MINI TWINKLING SIX PATTERNS LASER SHOW SYSTEM
the power supply, the input voltage and the fuse.
2. In Stand-Alone operation, if the power supply indicator is light up and sound active
indicator isn't light up, but the laser is shut off doesn't work.
A. Because sound is too small make for laser shut off in sound active, please increase the
music volume or increase audio sensitivity with sensitivity knob,
User's Manual
please check as below.
3. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.
After trying the above solution you still have a problem, please contact your dealer
or our company for service.
Light up your stage, disco, club, party, dj, Xmas, home, room, decoration place!
Read this manual before using. Do not attempt to open the housing or repair
this device by yourself without contact us!
Page 7