Table of Contents
Advertisement
Figure 6. Mounting points on the S360A
on the top/bottom and left/right side.
Colour
Indication
Solid greed
Normal state, normal operation
Blinking green
GLM is adjusting the monitor
Green blink every 10 sec.
Monitor is an ISS power saving sleep
state
Red blink
Power amplifier overload protection is
active (audio is modified because of
protection)
Solid red
Monitor is muted
Yellow
Monitor is not in the active (playing)
group
Yellow blinking
Overheat protection is active (audio is
modified because of protection)
Table 2. Monitor front panel light indications summary
the monitor. If the AES/EBU cable is operated in dual-wire mode,
the monitor detects this automatically and the channel selection
switches have no effect.
Level
The Level switches scale down the monitor output level in 10 dB
steps. The effects of these switches add up and combine with
the effect of the rotary level adjustment control. The combined
total setting range is -42 dB.
Stored
The Stored switch selects the use of the controls on the monitor's
back panel or the settings stored inside the monitor memory using
the GLM system calibration software. Setting the Stored switch to
OFF position selects the settings defined by the monitor's own rear
panel controls. Setting the Stored switch to ON position selects
the use of internally stored GLM settings. Using the Stored option
overrides all adjustments done with the monitor's own controls.
Front Panel Light
Normally, the light on the front panel is green. Red and yellow
colours are used to indicate special situations. See Table 2 for
more details.
6
Figure 7. The S360-450B side-side
bracket shown with wire suspen-
sion, a truss mount clamp and
S360-465B ceiling mount plate.
Figure 8. S360A Iso-Plate™ vibration decoupling platform
and the dual downward firing bass reflex ports.
Mounting
point 2
45-75°
Figure 9. Ceiling mount 8000-436 used with S360-424B
bracket. Note the use of different mounting points on the
bracket for different tilt angles.
Operating Environment
These monitors are designed for indoor use only. The
permissible ambient temperature is 15-35 degrees Celsius
(50-95°F) and relative humidity 20% to 80% (non-condensing).
When the product has been stored or transported in a cool
environment and is taken into a warm room, to prevent
condensation of humidity wait 0.5-1 hours before opening
Mounting
point 3
24-45°
0-24°
Mounting
point 4
Advertisement
Table of Contents
