Getting Started - Bosch XDK 110 Operating Instructions Manual

1 2 | XDK 110

2.3 Getting Started

• Start the software "XDK Workbench".
• The "Welcome" screen will appear.
• If an XDK is connected, the XDK symbol will appear.
• Create your application.
• Click on the "Flash" Button. Your application will be transferred to
the XDK.
• Check the output of the XDK by using the console of the
"XDK-Workbench"
2.3.1 Flashing the XDK 110
The XDK 110 can only be programmed while in bootloader mode. To
enter bootloader mode, press the "Flash" button. The software puts the
XDK 110 in bootloader mode, flashes the programm and reboot.
If the software does not put the XDK 110 in bootloader mode, this can
be done manually:
• Switch off the XDK 110.
• Press Button 1.
• Hold down Button 1 and switch the XDK 110 back on.
The red LED will light up. If a USB connection is already established, the
yellow LED will also light up. Press the "Flash" button
2.3.2 Demos
The software package contains three demos:
• Data Logger: Storage of sensor data on a Micro-SD card
• Virtual XDK: Renders an XDK that is connected to a tablet via
Bluetooth. The XDK on the tablet moves analogously to the real XDK.
• Sensor Monitor: Shows a 2-D view of the raw sensor data (samples
over time)
2.3.3 Toolbox
The Toolbox contains various function blocks and und algorithms, like
filters, FFT (Fast Fourier Transform) and more. For example, the toolbox
can help determine the spatial position of the XCK 110 by using the raw
data from the gyroscope and the accelerometer.
BCDS20141110V1 | 12.2014 Bosch Connected Devices and Solutions GmbH
english