Download And Installation; Connecting Xdk 110; Functional Limitations - Bosch XDK 110 Operating Instructions Manual

1 0 | XDK 110
2 Start-up and Software
The software for the XDK is online available. You can download the
software from http://www.xdk.bosch-connectivity.com. Go to the down-
load section to get the latest software package and demos.

2.1 Download and Installation

Download the software package "XDK Workbench" from the website
http://www.xdk.bosch-connectivity.com
software package contains all necessary components. Program examples,
demos and a Toolbox are included (please refer 2.3. "Getting started").

2.2 Connecting XDK 110

Connect the USB cable that was included in delivery to with the USB
connector of your PC and the Micro-USB Connector of the XDK.

Functional Limitations

notice
The device can be impaired or damaged if the power source is inadequate.
• Do not use cables >┘3 m.
• Use only certified USB power adapters
The XDK 110 uses the LED to show the following states:
After XDK 110 has been switched on the first time, a running light demo
will start.
LED Green:
The green LED shows the charging status and cannot be controlled by
software.
Continuous: Charging/Charging suspended by thermal loop.
Flashing: Safety timers expired
Off: Charging done/Recharging after termination/IC disabled
or no valid input power/Battery absent.
The following LED are active if the XDK is in bootloader mode:
LED Yellow:
Continuous: Bootloader mode active and USB connected; Driver loaded
LED Red:
Continuous: Bootloader mode active
Flashing 5x: No valid application detected; XDK remains in bootloader
mode
BCDS20141110V1 | 12.2014
and start the installer. The
Bosch Connected Devices and Solutions GmbH
english