Advertisement
3
REMOVE THE LENS (See Figure-3 and 4)
1
Remove the lens motor connector from terminal.
.
2.
Loosen the screws-B (2 screws) which fastens
the lens. {Use the driver (4 mm, Yellow) included
with the lens to loosen the screws.}
3.
Slide the lens lock latches to "UNLOCK" position
and remove the lens.
Be careful not to drop the lens when removing the
screws. After using, save the driver for latter use.
4
MOUNT THE LENS (See Figure-5)
1
Remove protective caps (front and back) on the
.
lens.
2.
Mount the lens on lens mounting bracket with
Upper 2 screws. (locate motor on left side).
Use the driver (4 mm, Yellow) included with the
lens to fasten the screws.
3
Remove the lower 2 screws on the Lens. (Lower 2
.
screws are not used.)
Slide the lens lock latches to "LOCK" position and
lock the lens. (See Figure-4)
Connect the lens motor connector to terminal.
4.
(See Figure-3)
LENS LOCK LATCHES
LOCK
POSITION
UNLOCK
POSITION
CONNECTOR
Fig-4
LENS MOUNTING
BRACKET
DRIVER
IN THE LENS
-5-
SCREW "B"
LENS LOCK
LATCHES
TERMINAL
LOWER SCREWS
Fig-3
Fig-5
Advertisement
