Advertisement
3
INSTALL THE LENS. (See figure-4)
1. Remove protective caps(front and
back) on the lens.
2. Mount the lens on mounting bracket
of the main cabinet with 4 screws.
Use the screws included with the lens.
Use the driver included with the lens to
fasten the screws.
(After using, save it for latter use.)
INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)
4
Install the light-block sheet around the lens
as shown in the illustration. Use the sheet
included with the lens.
When this projector permanently install in
the structure, slide the picture, obtain cor-
rect focus, then lock the lens by Focus Lens
Lock screw at this step.
5
MOUNT THE LENS COVER. (See figure-6)
When in install the both upper and lower
lens covers, install the light-block sheet so
that it should be placed in the guide slot.
(place of the cover plate had been placed.
See figure-2.) If the installation of light-block
sheet is incorrect, it will be the cause of
leakage of light or the dust entering at the
main cabinet.
1. Insert the upper part lens cover and fix
them with screws A (4 screws).
2. Insert the lower part lens cover and fix
them with screws B. (2 screws).
ATTACHED DRIVER
Adjust focus by rotating
the lens.
LENS MOUNTING BRACKET
FOCUS LENS LOCK SCREW
LIGHT-BLOCK SHEET
UPPER LENS COVER
A
B
LOWER LENS COVER
Fig-4
Fig-5
A
Fig-6
Advertisement
