Download Print this page

Ken A Vision Video Flex 5400 Installation Manual

Fume hood

Advertisement

Quick Links

3. Turn power off, and unplug power supply cord.
4. Then, turn power back on. At this point the same circumstances
should occur as item "2" above.
D. Finish
1. After verify working status of the camera system, plug back in
power supply DC plug. Route all the cables to outside of outer
panel, and then put outer panel back in.
2. It may be okay to leave power supply input plugged to the Fume
Hood AC line system.
Warranty
To activate the five year limited warranty on your new Video Flex
to www.ken-a-vision.com/warranty.htm or call 816-353-4787 and talk to one of our
customer service representatives.
Technical Support
Having trouble? Visit out support page at
www.ken-a-vision.com/support.htm
, either go on line
®
INS-5400.706
Video Flex
Fume Hood
®
Installation Manual
Part No. 5400

Advertisement

loading
Need help?

Need help?

Do you have a question about the Video Flex 5400 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ken A Vision Video Flex 5400

  • Page 1 To activate the five year limited warranty on your new Video Flex , either go on line ® to www.ken-a-vision.com/warranty.htm or call 816-353-4787 and talk to one of our customer service representatives. Technical Support Having trouble? Visit out support page at www.ken-a-vision.com/support.htm...
  • Page 2 Video image should show on the monitor and should be able to focus by adjust focusing knob. d. The same video image should show on the computer monitor (if you have installed ken-a-vision software in your computer).