Wide Mode Operation; Storing And Outputting Scenes - Zero 88 Juggler Operating Manual

Wide Mode Operation

In Wide Mode you are able to crossfade between, or combine two scenes which are 24
channels wide.
A scene is set up using both the PRESET A and PRESET B faders (PRESET A faders
control channels 1 -12, PRESET B faders control channels 13 - 24). This scene is then
stored temporarily by pressing the PRESET CONTROL button.
A second scene can then be set up on the PRESET A and PRESET B faders. The A
MASTER and B MASTER faders can then be used to crossfade between the two scenes.
The PRESET CONTROL button is used to control which of the master faders has control
of the PRESET channel faders and the stored scene. The GRAND MASTER is used to
control the final output levels from the desk. The FADE TIME control is used to determine
the crossfade time between the two scenes.

Storing and Outputting Scenes

Ensure that the desk is in Wide Mode (LED in WIDE button is on). On first entering Wide
Mode or re-entering Wide Mode, the PRESET faders will be assigned to the A MASTER,
and the stored scene assigned to the B MASTER. The lights in the PRESET CONTROL
button indicate this (A FADERS, B STORED).
Set the A MASTER and GRAND MASTER faders to full and the B MASTER fader to zero.
Ensure that the lights in the PRESET CONTROL button indicate A FADERS, B STORED
Set up a scene using the PRESET A and PRESET B faders. This scene will be output.
To store the scene press the PRESET CONTROL button. The output levels are
temporarily stored and the lights in the PRESET CONTROL button change to B FADERS,
A STORED. The A MASTER is now assigned to the stored scene and the B MASTER
assigned to the PRESET faders, so the outputs remain the same.
Set up the next scene using the PRESET A and PRESET B faders. The outputs are not
affected since the B MASTER is currently at zero.
To crossfade between the stored scene and the scene on the PRESET faders,
simultaneously move the A MASTER to zero and the B MASTER to full.
Press the PRESET CONTROL button. The output levels are saved into the temporary
store (overwriting the previous values) and the lights in the PRESET CONTROL button
change to indicate A FADERS, B STORED. The B MASTER is now assigned to the stored
scene and the A MASTER to the PRESET faders, so the outputs remain the same.
Repeat the operations described above to set up a new scene on the preset faders,
crossfade to the new scene, and save it to a temporary store etc..
Page 6 Juggler 73-404-00 Issue 1