EMC Isilon NL400 Installation Manuals page 15

Setting
int-a network settings
Netmask
l
IP range
l
int-b / failover network settings
Netmask
l
IP range
l
Failover IP range
l
ext-1 network settings
Netmask
l
MTU
l
IP range
l
Default gateway
SmartConnect settings
SmartConnect zone name
l
SmartConnect service IP
l
DNS settings
DNS servers
l
DNS search domains
l
Date and time settings
Time zone
l
Day and time
l
Cluster join mode
Description
The default character encoding is UTF-8.
The network settings used by the int-a network. The int-a
network is used for communication between nodes.
The int-a network must be configured with IPv4.
The int-a network must be on a separate subnet from an
int-b/failover network.
The network settings used by the optional int-b/failover
network. The int-b network is used for communication
between nodes and provides redundancy with the int-a
network.
The int-b network must be configured with IPv4.
The int-a and int-b networks must be on separate
subnets.
The failover IP range is a virtual IP range that is resolved
to either one of the active ports during failover.
The network settings used by the ext-1 network. The
ext-1 network is used by clients to access the cluster.
The default ext-1 network can be configured with IPv4 or
IPv6 addresses.
You can configure the external network with IPv6
addresses by entering an integer less than 128 for the
netmask value. The standard external netmask value for
IPv6 addresses is 64.
If you enter a netmask value with dot-decimal notation,
you must use IPv4 addresses for your IP range.
The IP address of the optional gateway server through
which the cluster communicates with clients outside the
subnet. Enter an IPv4 or IPv6 address, depending on
how you configured the ext-1 network settings.
SmartConnect balances client connections across nodes
in a cluster.
For information about configuring SmartConnect, see the
OneFS Administration Guide .
The DNS settings for the cluster.
Enter a comma-separated list to specify multiple DNS
servers or search domains. Enter IPv4 or IPv6 addresses,
depending on how you configured the ext-1 network
settings.
The day and time settings for the cluster.
The method that the cluster uses to add new nodes.
Choose one of the following options:
Run the configuration wizard
Install a new node
15