HUSTLER Z Diesel Operator's Manual page 29

THREE POINT TURN
Step 1
Step 2
Step 3
Neutral
Right control lever
Figure 3-16
603695
Left control lever
3-9
Operating Suggestions
An inexperienced operator should not mow on
slopes or on uneven terrain.
Before attempting normal speed operation an
inexperienced operator should:
• be thoroughly familiar with the proper use
and operation of the equipment.
• read the manual completely and thoroughly.
• have attempted slow moving maneuvers.
If you lose steering control while operating the
machine, place the steering control levers in the park
brake position immediately. Inspect the machine and
involve your Hustler
before continuing to operate.
The unit's steering control levers are very
responsive: Easy does it! For smooth operation,
move the levers
movement. Skill and ease of operation come with
practice and experience.
very rapidly. Use caution when making turns and
slow down before making sharp turns.
Inexperienced operators may have a tendency to oversteer
and lose control. Practice slow maneuvers at low engine rpm
(idle) on a flat open area before attempting normal speed
operation.
Sharp depressions or raised obstacles (such as
gutters or curbs)
approached at high speed in an attempt to "jump"
them as the operator could be thrown from the
equipment. Approach at a slow speed and angle
one drive wheel at the obstruction. Continue at an
angle until the wheel clears and then pivot the
opposite wheel around.
When turning on soft wet turf, keep both wheels rolling
either forward or backward. Pivoting on one stopped wheel
can damage turf, especially when mowing.
Set the throttle at full rpm for maximum performance. This
gives maximum power to the drive wheels and deck when
needed. The throttle setting directly controls blade speed.
Use the control levers to control ground speed rather than
engine rpm.
Keep blades sharp. Many problems with incorrect cutting
patterns are due to dull blades or blades which have been
sharpened incorrectly. Information on sharpening blades is
listed in this manual's maintenance section. Blade sharpness
should be checked daily.
Dealer to resolve the problem
®
slowly, avoiding sudden
The machine can spin
should not be directly
REV J