Hypertech 2000 Reference Manual And Step By Step Installation Manual page 2

Device Info ................................................................................................................................................................... 23
Vehicle Info .................................................................................................................................................................. 24
Settings .......................................................................................................................................................................... 24
SECTION 2: BACK TO STOCK OR CHANGING TUNING OPTIONS .................................................................. 25
Back To Stock ............................................................................................................................................................... 25
Changing Options ......................................................................................................................................................... 25
Preset Tune ................................................................................................................................................................... 26
SECTION 3: TECHNICAL INFORMATION & TROUBLESHOOTING ................................................................. 27
3-1: WHAT TO DO BEFORE TAKING THE VEHICLE IN FOR SERVICE ............................................................... 27
3-2: TROUBLESHOOTING GUIDE ............................................................................................................................... 27
SECTION 4: UPDATING YOUR PROGRAMMER .................................................................................................... 28
SECTION 5: PRODUCT WARRANTY & CONTACT INFO ..................................................................................... 29
5-1: FACTORY DIRECT LIMITED LIFETIME WARRANTY ..................................................................................... 29
5-2: EMISSION LEGALITY STATEMENT ................................................................................................................... 29
5-3: CONTACT INFORMATION ................................................................................................................................... 30
SECTION 6: DYNO CHART ........................................................................................................................................... 31
PLEASE READ BEFORE USING PROGRAMMER!
The installation process is very easy and should not take long for programming and installation to be
accomplished. To avoid problems with installation, observe the following recommendations:
• It is very important in the programming process that the vehicle's battery is fully charged and there
is no drain on the battery. DO NOT program with a battery charger connected to the vehicle.
• Close and keep all doors shut. (This eliminates interior lights and alarms from sounding.) If it's hot,
roll the window(s) down BEFORE programming the vehicle.
• TURN OFF all electrical accessories (radio, heater/AC blower, wipers, etc.) that will power up when
the key is in the "Run" position. Do not operate any electrical accessories during the programming
process.
• Non-factory electronics, such as stereo amplifiers, CB radios, and aftermarket alarms should be
disabled before programming.
• Unplug all accessories from cigarette lighter or any other auxiliary power port on the vehicle
BEFORE programming (cell phone chargers, GPS, etc.)
• Disconnect any mobile devices from the entertainment system BEFORE programming (Bluetooth,
USB chargers, smart phones, etc.)
• Daytime running lights should be disabled before programming. See vehicle owner's manual for
information on how to turn off.
After inspecting the vehicle and disconnecting power from any non-factory electronics, continue with the
installation of the programmer.
Once the programmer cable has been connected to the vehicle's diagnostic port and to the programmer, DO
NOT remove or disturb the cable during the ENTIRE programming process. Only remove the cable from the
diagnostic port when prompted by the programmer at the end of the installation process.
2