Download Print this page

Hotpoint CB310 Quick Manual page 4

Advertisement

What to do if...
The temperature inside the
compartments is not low
enough.
There is water on the
bottom of the refrigerator
compartment.
The front edge of the
appliance, at the door striker
seal, is hot.
The red
icon is flashing
and a sound signal is
activated
The red
icon is flashing,
a sound signal is activated
and the
icon is
activated.
The red
icon is lit up
(without flashing), a sound
signal is activated and the
freezer temperature display
is flashing.
The red
icon will light
up, a sound signal is
activated and the letter "F"
is flashing on the display.
* Available only on certain models
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website
Using QR Code
Alternatively,
contacting our After-sales Service, please state the codes provided on your product's identification plate.
Possible reasons
There could be various causes (see
"Solutions").
The defrost water drain is blocked.
This is not a defect. It prevents
condensation from forming.
Door open alarm
It is activated when the refrigerator and/
or freezer compartments door remains
open for a prolonged period of time.
Blackout alarm
This activates when there is a prolonged
interruption to the power supply which
has caused an increase in temperature
in the freezer compartment.
Note: until the blackout alarm is
deactivated, you cannot set a different
temperature for the product.
Freezer compartment temperature
alarm
The freezer compartment temperature
alarm indicates that the compartment
is not at the optimum temperature. This
may occur: when using for the first time,
after defrosting and/ or cleaning, when
freezing large quantities of food or
when the door to the freezer does not
close completely.
Malfunction alarm
The alarm indicates the malfunction of a
technical component.
docs . hotpoint . eu
contact our After-sales Service
Solutions
Check that:
the doors close properly;
the appliance is not installed near a heat source;
the set temperature is adequate;
the circulation of air through the ventilation of the appliance is
ensured.
Clean the defrosting water drain (see section "Cleaning and
Maintenance").
No solution is necessary.
To turn the sound signal off, close the open door of the product.
Before turning off the sound signal, it is recommended that you pay
attention to the temperature shown on the temperature display,
corresponding to the highest temperature reached in the freezer
compartment during the power cut. To turn the sound signal off,
briefly press the "Turn off sound alarm" button.
After pressing the button, the temperature display will again show
the temperature set. If the freezer compartment has not yet reached
the optimal temperature for the preservation of the food, the
freezer compartment temperature alarm may activate (see freezer
compartment temperature alarm). Check the condition of the food
before consuming it.
To turn off the sound signal, briefly press the "Turn off sound alarm"
button (the temperature display will stop flashing). When the
optimum temperature conditions have been reached, the red icon will
automatically turn off. If the freezer compartment temperature alarm
continues, contact the Authorised Technical Assistance Service.
Call the authorized Technical Assistance Service. To turn the sound
signal off, briefly press the "Turn off sound alarm" button.
(See phone number in the warranty booklet). When
400011231802

Advertisement

loading

This manual is also suitable for:

Cb380