Local Setting Menu - AMC OCTO User Manual

Software interface

Local setting menu

DEVICE LIST
and OCTO are located in the same network segment. Default OCTO IP address
is 192.168.1.10 Sub net mask: 255.255.255.0 Gate way: 192.168.1.1. This address
can be changed after you connect to DSP first time by using default IP.
Pay attention: The only one user can be connected at the same time.
06 USER MANUAL OCTO Digital signal processor
CONNECT
Click connect in local setting menu to establish communication between OCTO
software and DSP. The same function can be done by using double click on the
IP address in device list window or by using
window. If OCTO software can't find IP automatically, instead of login window
will be displayed device list. After IP selection connection procedure will be
continued.
Local setting menu
LOGIN WINDOW
Connection to DSP must
be started by choosing the
device from device list. If
device is not listed, press
"Search" button to get a list
of all OCTO IP addresses
which are available in local
network. Before searching
make sure that computer
DISCONNECT
This button stops communication between DSP and OCTO software without
the closing program window. The analogue function can be enabled by using
User name and password must be added
to "identify" window in order get access to
OCTO user interface.
Default user name: admin
Default password: 123456
icon in the main program's window.
icon in the main program's