AMC OCTO User Manual page 32

Software interface
CAMERA SETTING
It's a tool to create video camera position presets. There is a possibility to create
32 presets with different video camera positions. These presets will be assigned
to audio inputs in "Mic trace settings". Before the made preset, main camera
settings: serial interface, camera address, and protocol must be set according
your video cameras. Camera movement speed can be selected in "Speed
"selector. This speed setting is designed to use in preset configuration moment
only. Camera speed parameter will not be added to preset. In order to create
a preset, camera positions must be set by using "Up", "Down", "Left" and "Right"
navigation keys and after selecting preset number in the "preset" window saved
by pressing "Save" button.
Serial dedicated to set control interface. There are two choices RS232 and
RS485. Please sure to set the same interface as your camera is connected to
OCTO.
30 USER MANUAL OCTO Digital signal processor
Camera addr all cameras must be assigned with different addresses in order to
send control commands exactly to needful camera. Please check video cameras
user manual to learn how to set up addresses.
During the voice tracing configuration camera address must be specify to
"Camera addr" window.
Protocol It's a window for video camera control protocol setting. There are
availability to use PELCO and VISCA protocols.
Speed – video camera movement speed. Lower speed helps to set camera po-
sition more precisely. Camera speed parameter will not be added to preset, so
camera will use default speed when voice tracing operates in automatic mode.
Up, Down, Left, Right - navigation buttons to set video camera position.
Zoom in, Zoom out – buttons to control camera zoom function.
Focus in, Focus out - buttons to control camera focus if video camera doesn't
have auto focus or this function is disabled.
Large A, Small A – It's camera aperture control. Useful if video camera doesn't
have auto aperture.
Call – allow to call and test already saved preset. Preset number must be select-
ed before the call function activation.
Save – Saves camera position in to preset which number is set to "Preset"
selector.
Clear – Designed to delete preset settings.
Please note: Save tracking configuration to the device in "Scene manager"
settings in order to keep your configuration after power reboot.