Advertisement
Quick Links
TROUBLESHOOTING
Problem
- The Box is leaving edges.
Cause
- The Flat Box blade is not correctly adjusted.
Solution
- Check the Flatbox blade is set 1 – 1.5mm above the skids. This setting can be
done by tightening the AT042 on the side of the brass blade holder.
Problem
- The joint compound has a pothole effect.
Cause
- The coat is too thick.
Solution
- Adjust the blade setting by increasing the tension on the ratchet. This will
remove the excess compound and leave a smooth finish for minimal sanding.
Problem
- The Box is leaving hollow joints.
Cause
- The coat is too thin.
Solution
- Adjust the blade setting by
decreasing the tension on the ratchet.
For further information contact:
Tape-Pro Drywall Tools Pty Limited | 4/76 Dover Drive, Burleigh Heads QLD 4220 Australia
Phone: +61 7 5520 6022 Fax: +61 7 5520 5973 Email: info@tapepro.com
Website: www.tapepro.com
TAPEPRO FLATBOX
Advertisement
Related Manuals for Tapepro Flatbox
Summary of Contents for Tapepro Flatbox
- Page 1 - The Flat Box blade is not correctly adjusted. Solution - Check the Flatbox blade is set 1 – 1.5mm above the skids. This setting can be done by tightening the AT042 on the side of the brass blade holder.
- Page 2 Tapepro Flatbox Handle. The Tapepro Loading Pump and Flat both Tapepro and Premier Flatbox Handles. (FB-8) Box Filler Nozzle are also available to make filling your flatbox quicker and easier. The Tapepro range of tools and parts is also compatible with the Premier Drywall Tools and Accessories. CLEANING Your Tapepro Flatbox should be cleaned after every use to maximise lifespan and maintain optimal performance.