Advertisement
WIRING DIAGRAM
PIE WARMER
MODEL CODE: PWK0007 R01
LEGEND
DESCRIPTION
B1
THERMOSTAT
L1
INTERIOR LIGHT
E1
ELEMENT 750W/230V
SI
ROCKER SWITCH
230V
N
S1
PART NUMBER
1-THERMO-BM-UL
1-LB-PWA0001
5-750-PWA0002
1-RS-NI
L
E
L1
B1
E1
7
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
SAFETY
READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO
WIRING DIAGRAM
FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO
YOURSELF AND OTHERS
MODEL: PIE WARMER
MODEL CODE: PWA0002
1.
When this appliances is to be positioned in close proximity
to a wall, partitions, kitchen furniture, decorative finishes, etc.
it is recommended that they be made of non-combustible mate-
rial. If not, they shall be clad with a suitable non-combustible
LEGEND
DESCRIPTION
heat insulating material, and the closest attention be paid to fire
THERMOSTAT
B1
prevention regulations.
E1
ELEMENT 750W / 230V
2.
Do not operate without the crumb tray, as it will cause burn
L1
INTERIOR LIGHT 230V
marks on the counter top.
ROCKER SWITCH
S1
3.
Use the appliances on an individual 15A mains outlet only.
4.
Ensure that the equipment and the power supply cord does not
come into contact with hot surfaces.
5.
Supervision is necessary when the appliance is used in close
proximity to children.
6.
If the supply cord is damaged, it must be replaced with a new
cord assembly available from the suppliers agent.
7.
Use only earthed outlets matching the serial plate voltage.
8.
Have equipment installed by a qualified person in accordance
with local codes and ordinances.
9.
Use equipment in a flat level position.
10. The equipment may be hot, even though the pilot light is not on.
11. Do not operate if equipment has been damaged or is malfunc-
tioning in any way.
12. These appliances are designed to run only on alternating current
(A.C.) DO NOT CONNECT TO DIRECT CURRENT (D.C)
WARNING
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
PART NUMBER
1-THERMO-BM-UL
5-750W-PWA0002
1-LH-PWA0001
1-RS-NI
DO NOT OVERLOAD THE CIRCUIT.
4
Advertisement
