Advertisement
Quick Links
LIMITED WARRANTY
All equipment which is sold under ANVIL trademark and used for
commercial purposes is warranted against defects in materials and
workmanship. The warranty runs for one year from the date of origi-
nal installation and is for the benefit of the original purchaser only.
All other Warranties ,expressed or implied , statutory or otherwise,
including without limitations any implied Warranty of Merchantability
or fitness for purpose are excluded .The Seller shall in no event be
liable for direct,indirect or consequential damages in connection with
ANVIL commercial products.
The Sellers obligation under this Warranty is limited to the re-
pair of defects without charge. Defective units must be taken or
shipped,transportation charges prepaid,to ANVIL.
This Warranty is not effective if damage occurs because of
accident,carelessness,improper installation,lack of proper set-
up,supervision when required or if the equipment is installed or
operated in any manner contrary to the installation and operating
instructions. In these cases,repairs will be made at a reasonable
cost. Work performed by unauthorized personnel or unauthorized
service agencies using non Anvil spares voids this Warranty.
NB:
REGISTER ON-LINE TODAY
Register your warranty on-line now at www.anvilworld.com
NO WEB ACCESS
If you do not have access to the Web. Kindly register by completing
the warranty registration form and fax it to the ANVIL office in the
country of purchase.
Failure to do so will invalidate your warranty.
4-INS-PWK0007 R03
PIE WARMER
INSTALLATION OPERATION AND CARE OF
PIE WARMER
MODEL: PWK0007 R02
Advertisement
Summary of Contents for Anvil PWK0007 R02
- Page 1 NO WEB ACCESS If you do not have access to the Web. Kindly register by completing the warranty registration form and fax it to the ANVIL office in the country of purchase. Failure to do so will invalidate your warranty.
- Page 2 UNPACKING NOTES Unpack the product and check for any damage incurred during transit. This should be reported to the responsible carrier, railway or postal authority, and a request for a damage report should be made. THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR PROTECTING AGAINST LOSS FROM CONCEALED DAM- AGE.
- Page 3 SHELF RUNNER GASTRONORM PAN GASTRONORM HOLDER DISPLAY GLASS FRONT GLASS DOOR DOOR KNOB PERANO BUTT HINGE FOOT CABLE GRIP POWER CORD CRUMB TRAY BOTTOM COVER ELEMENT TEMPERATURE GAUGE FASCIA PANEL KNOB PILOT LIGHT NON ALUMINATED ROCKER SWITCH THERMOSTAT ANVIL AIRE LOGO...
- Page 4 EXPLODED DIAGRAM MINI PIE WARMER WARNING EXPLODED DIAGRAM MODEL CODE PWK0007 R03 MINI PIE WARMER MODEL CODE: PWK0007 R03 Burn Hazard. Do not touch hot food,liquid or heating surfaces while equipment is heating or operating Hot surfaces and food can burn skin. Allow the hot surfaces to cool before handling CLEANING Always ensure that the unit is disconnected from the mains...
- Page 5 WIRING DIAGRAM WARNING PIE WARMER MODEL CODE: PWK0007 R01 Electric Shock Hazard. Keep water and other liquids from entering the inside LEGEND DESCRIPTION PART NUMBER of the equipment. Liquid inside the equipment could THERMOSTAT 1-THERMO-BM-UL cause an electrical shock INTERIOR LIGHT 1-LB-PWA0001 Do not spray water or cleaning products.
-
Page 6: Electrical Connection Information
DESCRIPTION VOLTS POWER MODEL: PWK0007 R02 (V/Hz) PWK0007 R02 PIE WARMER 230V/50Hz IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF THE UNIT AS FOUND ON THE SERIAL PLATE. THE SE- RIAL PLATE IS LOCATED AT THE REAR OF THE UNIT ADJACENT TO THE INCOMING CABLE ENTRY.