Set-Up And Basic Adjustment; Adjustment Of Port-A-Filter Clamp - Barista Technology Puqpress 1-000-11 Series Instruction Manual

6 Lower clamp
7 Fastening screw for port-a-filter clamp
8 Display
9 Ground coffee basket
10 Anti-slip foot
11 Main housing – back cover
12 Main switch – on/off
13 Power inlet socket
4

Set-up and basic adjustment

You have received your tamper in operating condition. Now you only
need to adjust the lower clamp. Proceed as follows:

4.1 Adjustment of port-a-filter clamp

The tamper is designed so that all different port-a-filters from
various espresso machines fit into the clamp ( pos.3 & 6 ) for even
and level tamping.
The lower clamp should be setup correctly. Failure to adjust the
lower clamp to optimum working position may allow contact
with dangerous moving parts.
Proceed as follows for adjustment of the port-a-filter clamp:
1. Retract the power cord from the socket at the back side.
2. Lay down the tamper with the back side on a table and secure
the tamper.
3.
precision coffee tamper
EN
7