M12 x 1.5 40MM Full THD GR.8.8 M12 x 1.5 Wheel Lug nut 3/4" Hex Master Lock Cable, 6ft Looped Delrin Washer (In-House Fab) 5/16" Quick Link Polyurethane Bushing 1/2 USS Flat Washer Zinc Yellow 1/2" Flat Washer SAE Zinc Yellow Bracket M14 Bracket M12 1/4-20x 7/8 GR8 Hex Bolt...
Page 3
1. Make sure vehicle is turned off and the emergency brake is set before installing this product. 2. Remove hitch pin and ball mount. 3. Liberally grease the bolt and anti-rocking wedge-lock on the end of the receiver insert. See Figure 1. 4.
Page 4
14. Mount the wheel /tire to the HitchGate tire mount using the supplied hardware matching the bolt size to the upper mounting bracket size. Use a minimum of 3 lug bolts at all times. Full size trucks and SUV’s use 4 total lugs. 15.
Page 5
Figure 1. Grease wedge-lock before inserting into receiver. Figure 2. Tighten the wedge-lock bolt to 75 ft/lbs. HITCHGATE 4/16/2007 BASIC...
Page 6
Figure 3. Mounting HitchGate Swing Arm to Receiver Arm HITCHGATE 4/16/2007 BASIC...
Page 8
Wilco Products Warranty and Warnings Wilco Products provides a Limited Lifetime Warranty to the original retail purchaser who owns the vehicle, on which the product was originally installed, for defects in workmanship and materials. The Limited Lifetime Warranty excludes the following Wilco Products items; latch bushings, safety cable assembly, bolts, nuts, latch pins, tether cable, and thrust washers.
Need help?
Do you have a question about the Hitchgate UHG1060 and is the answer not in the manual?
Questions and answers