Advertisement
Quick Links
ZXMK2-USER-REV1
FITMENT CENTRE STAMP:
SANJI Security Systems (Pty) Ltd
68 Kyalami Boulevard, Kyalami
Business Park Midrand 1684,
Gauteng, South Africa
TEL +27 11 875 0000
FAX +27 11 466 0286
E-mail: sales@sanji.co.za
ISO 9001:2008
http://www.sanji.co.za
quality company
TA-2013/037
SanjiMXMk2InstructionManual.indd 1
26) USING YOUR PINCODE OVERRIDE
(ZX400Mk2 ONLY)
The ZX400Mk2 can be temporarily overridden by entering the supplied 5
digit pincode override by means of turning the ignition switch on and off
in a sequence as per instructions below. If the unit is in immobiliser armed
mode (dash led solid) you can begin to enter your code. If the alarm is set,
open the door and turn the ignition on. Wait for the unit to stop sounding,
turn the ignition off. You can begin to enter your code.
Digit 1 [number 3]
Turn ignition key on, led will start to flash, on the THIRD flash, turn
ignition key off, the indicators will flash once, you have now successfully
put your first digit in.
Digit 2 [number 1]
Turn ignition key on, led will start to flash, after the FIRST flash, turn
ignition key off, the indicators will flash once, you have now successfully
put your second digit in.
Digit 3 [number 4]
Turn ignition key on, led will start to flash, after the FOURTH flash, turn
ignition key off, the indicators will flash once, you have now successfully
put your third digit in.
Digit 4 [number 2]
Turn ignition key on, led will start to flash, after the SECOND flash, turn
ignition key off, the indicators will flash once, you have now successfully
put your fourth digit in.
Digit 5 [number 1]
Turn ignition key on, led will start to flash, after the FIRST flash, turn
ignition key off, the indicators will flash once, you have now successfully
put your fifth digit in and have successful overridden your vehicle.
If you enter an incorrect digit the unit will not flash the indicators and will
revert back to the first digit. If you enter an incorrect digit 3 times the
unit will sound the alarm. Turn the ignition on and wait for the unit to
stop sounding. You can now re-enter your code.
27) AUTO RE-ARM
(safety against code jammers)
*
The unit will Auto re-arm after 30 seconds if the user has unlocked the
vehicle via the remote and not pressed the set button on again. The alarm
will only Auto re-arm and lock the doors if no doors or ignition has been
pulsed.
ZX300Mk2 ONLY
To override
In any mode, t
urn the Ignition on
28) ONE EVENT
the
and press the hidden push button
OVERRIDE
immobiliser
for +/- 2 seconds until the unit
or alarm, in
chirps once, the system will be
reset. This is a once off
the event of
a flat remote
override.
battery.
REQUIRES A 3 BUTTON REMOTE
To open the
Press the boot release button
29) BOOT
boot.
(ignition off). The boot will open.
RELEASE
If the alarm was set the boot will
FUNCTION
open and the alarm will be reset.
2013/08/15 2:37 PM
Advertisement
