Sanji Dx120 series User Instructions

The Dx120 series represents a milestone in affordable vehicle
security design. Sanji have incorporated the most up to date
technology to improve performance and long term reliability.
Manufactured to full international ISO 9001 and SABS quality
standards. Please read these instructions for correct system
operation.
Points marked with the * are applicable to the DX120iHJ
version only
1) SETTING THE
ALARM
2) DOOR WARNING
CHIRPS
3) ALARM DELAY
PERIOD
Dash led
flashing
rapidly
4) ALARM ARMED
MODE
Dash led
flashing
slowly
5) ALARM ARMED
CONFIRMATION
6) RESETTING
THE ALARM
7) TRIP CHIRPS
to enable the Press the double dot
immobiliser button (right button), the
and full unit will sound 2 chirps
alarm and the indicators will
features. flash twice. If fitted with
central locking the doors
will lock.
Door warning When you set the alarm,
chirps. if a door is open, you will
get 2 loud chirps warning
the user that a door is
open.
The alarm During the alarm delay
delay period is period the dash led will
30 seconds. flash rapidly. The
immobiliser is armed,
however the doors and
ignition are not armed at
this point. After 30
seconds, the dash led will
flash slowly, doors and
ignition are now armed.
During alarm The immobiliser, doors and
armed mode ignition are now fully
the dash led armed. If a door is opened
will flash or ignition is turned on,
slowly. the system will trigger,
siren will sound for 35
seconds, then go back to
alarm armed mode.
To confirm Press the double dot
alarm armed button, the indicators will
mode. flash once to confirm that
the alarm is fully set.
to reset the Press the single dot
immobiliser button (left button), the
and full unit will sound 1 chirp
alarm and the indicators will
features. flash once. If fitted with
central locking the doors
will unlock. The dash led
will go off.
Trip chirps on If the alarm tripped when
reset. the user was not present.
When you reset the alarm,
the unit will sound
4 chirps.