Advertisement
3. Carry slide to the water and position
next to the O-Zone directly opposite
from the boarding platform.
4. Tie a knot at one end of each slide
attachment rope.
5. Working from the top down, feed the
rope through mounts A through F as
shown. Loop twice through point E and
finish by tying at point F.
6. Lace other side of slide in the same
fashion.
7. Adjust connection lacing, if necessary,
to provide equal tension on both sides
and to ensure the slide is squarely and
securely fastened to the O-Zone.
8. Move to proper water depth and attach anchor
bag rope to the single rope holder located low
on the outside of the tube, opposite the
boarding platform. Adjust anchor line to a length
slightly greater than the water depth and tie off rope. Leave a little
slack in the anchor line to accommodate the vertical motion of the
O-Zone when in use.
Before using your O-Zone, please read and follow all warnings and
safety instructions.
5
E
Advertisement
