Advertisement
7. Carry (DO NOT DRAG) your O-Zone product to the water. Flip
bouncer upside down in shallow water. Tie a knot in one end of
lacing rope. Align large grommet holes
of apron over the three rope holders on
the underside of the boarding platform.
Starting at the outermost rope holder on
the bottom of the bouncer, lace
alternately between bouncer and
boarding platform. Loosely tie other end
of rope.
Flip entire unit face up in the water. Pull
rope until the platform is snug against
side of bouncer and there is no gap.
Check to make sure rope is spread
evenly between rope holders. Tie off
rope to keep the boarding platform snug
to the bouncer.
Periodically check to ensure the
protective apron is laying flat over the ropes and the ropes are
not exposed between the boarding platform and the bouncer.
Inflating and connecting the slide
1. Inflate the main body chamber of the slide. DO NOT OVER
INFLATE. Inflate until firm and the slide stands upright.
2. Inflate both side rails on top of slide until firm. DO NOT OVER
INFLATE as the heat of the sun will cause the air to expand.
Release air throughout day if necessary.
Note: Moisten the plug of the clear stem valve prior to inserting it
into the valve and push plug into the valve body fully.
4
Advertisement
