Bosch GKF125CE Operating/Safety Instructions Manual page 19

2610052572_GKF125CE 9/18/18 12:11 PM Page 19
6. Perform the routing operation,
following the instructions in the
"Feeding the Router" section that
begins on page 14 of this manual.
7. Unlock the plunge lock lever. This
will allow the router bit to
disengage the work.
8. Turn the router off.
▶ The PR012 Router Dust
Collection for Plunge Base
This dust extraction hood is designed
for use the plunge base (PR111)
when routing is done in the middle of
the workpiece, such as when creating
slots or routing patterns for inlays. If
you have a shop vacuum system, you
can attach the dust extraction hood
for improved visibility, accuracy and
utility, particularly in freehand
routing.
To attach, position as shown and
secure adapter to base with the
thumbscrews provided (Fig. 21).
The dust extraction hood can also be
installed with the hose outlet facing
the front of the tool.
▶ Edgeforming Dust Extraction
Hood RA1175
router is ON or plugged in. To avoid
entangling hoses, do not use this
dust extraction hood at the same
time as any other dust extraction
hood.
This dust extraction hood (optional
accessory) is used for dust collection
when edge-forming (Fig. 22).
▼ ATTACHING DUST EXTRACTION
HOOD
You can attach the edge-forming hood
in several places according to your
needs or preferences. The dust hood
is attached to the plunge base using
two M4 thumb screws Two auxiliary
holes are provided in the plunge base
for attachment. Attach the dust
extraction hood — over the router's
sub-base — using the screws provided
Operating Instructions
Do not reach in area
of the bit while the
FIG. 21
Dust Extraction Hood
(Optional Accessory)
WORKPIECE
EDGE
FIG. 23
SUBBASE
M4 x 16mm
SCREW
with the hood. Securely tighten the
screws. (Figures 22 and 23).
19
M4 Thumb
Screws
FIG. 22
ROUTER
SUBBASE
DUST EXTRACTION
HOOD
M4 x 16mm
SCREW
DUST EXTRACTION
HOOD