Assembly Instructions for cable gland:
PSG 553/RAC
Operating temperature range -60°C +80°C
4
5
6
Cable Preparation
Armour/braid
3
2
1
Shroud Option
A
Strip Cable to suit equipment as shown above and
expose the armour/braid 'I' removing all cable fillers.
'I' = 20mm for cable gland sizes Os to C
'I' = 25mm for cable gland sizes C2 to F
'II' = to suit equipment.
If required, fit shroud.
Connection Solutions
Hawke International is a division of Hubbell Ltd.
Registered No. 669157 in England. Registered Office:
Cannon Place, 78 Cannon Street, London EC4N 6AF.
A member of the Hubbell Group of Companies
1
2
3
1. Backnut
2. Middle Nut
3. Reversible Armour Clamping Ring (RAC)
4. Armour Spigot
5. Seal
6. Entry (with captive deluge seal), if required
II
I
I
Note:
Tape armour must be
re-trimmed at 90° to the
vertical axis of the cable
after it has been spread,
to ensure that the full
face is correctly
presented.
B
Push the cable through the armour spigot . Spread
armour/braid over the armour spigot until the end
of the armour/braid is up against the shoulder of the
armour cone. Position the armour clamping ring .
www.ehawke.com
UK Office
Oxford Street West,
Ashton-Under-Lyne,
Lancashire. OL7 0NA. UK
Gland Preparation
4
3
2
1
Sales: +44 (0) 161 830 6698
Technical: +44 (0) 161 830 6697
Fax: +44 (0) 161 830 6648
E-mail: sales@ehawke.com
AI 312 / Issue R - 06/17
Certification Details
Gland Type: PSG 553/RAC
Exdb IIC Gb, Exeb II Gb, Extb IIIC Db
Baseefa06ATEX0056X
IECEx BAS06.0013X
IEx 14.0272X
EAC ТC RU C-GB.ГБ05.B.00750
CNEx07.0897X
Reversible Armour Clamping Ring (RAC)
General identification ring orientation for:
SWA
Position
IMPORTANT: The arrowhead indicating the
correct armour thickness or type should point
towards the equipment
Note: Cable acceptance sizes are marked on the
diaphragm seal, clamping ring and backnut.
C
Remove the inner seal from the entry . Place
the entry over the armour spigot . Move the
sub-assembly and up to meet the entry .
For any enquiries within EAC countries,
please contact:
MACDEM
P. O. Box 16, Moscow, 119571, Russia
Tel / Fax: +7 595 778 1264
Email: office@macdem.ru
Website: www.macdem.ru
II 2 GD IP66
Braid 'X' ,
Flat Steel Wire 'Y' ,
Steel Tape 'Z'
Ring Position
6
5
4
3
2
1
Images are for illustration
puproses only.
Product supplied may differ
slightly from that shown.
AI 312 - Issue R / Page 1 of 2