Alert-it P137 Quick Start Manual

Quick Start Guide to using the P137 Advanced Pager

Press menu for 3 seconds to turn on. (If no
response, then charge battery for at least 5
minutes)
Enter MENU (see overleaf)
Scroll right to Turn Off & then Select (up arrow)
Do not remove batteries as this can damage the connec-
tions.
Shows battery
status
(Charger can
be left
permanently
connected or
it can boost
charge from
empty in 8
hours)
Try walking towards the user's room. If the alarm cancels
then there is a problem with the building or distance
required. Contact Alert-It who can offer a signal booster
or if RF Fail does not cancel then:
1. Look for signs of damage and the status of
LED's/Display on clients equipment.
2. Check the user equipment is turned on.
3. Contact Alert-It for further advice
Indicates there is Name of alarm
an alarm system will flash up
in the area, not when safety
paired to this signal received.
pager. This may Bars on right
be OK or an error show strength
so check with the of signal
supervisor
Radio contact with
an alarm fitted with
"Safelink" security
has been lost. This
MUST be corrected
immediately i.e.
Epilepsy Alarms
UQ1043 Quick Start P137 Pager.ppp Page 1of 3 v8.1 26/04/2017
Typical alarm
indication. with
four levels:
Urgent, Help,
Assist, Fault
1. Attend the user,
2. Reset the alarm on the user's equipment and
the pager will return to normal operation
automatically
(Increased tone indicates more alarms are active.
See over for snooze and view.)